Condesate Return System RFQ Form

Name:
Company:
Street:
City:
State:
Zip:
Email:
Phone:
Fax:

Application Data

(please complete ALL fields in the form below, then select any desired options)

Provide Condensate Return System type: Simplex Duplex
This unit is to be rated for sq.ft. E.D.R.gpm @ psig.
Pump(s) to be series SPK or CRK as manufactured by Grundfos Pumps Corporation and have 304 stainless steeel impellars, casings, inlet strainer screen, suction inducer, and seal parts. Pumps suitable for operation to 210F.
Motor(s) to be hp rpm volts phase 60 hertz with TEFC enclosure.
Receiver to be 304 stainless steel with minimum 12 guage thickness and with "vent, "inlet, and 1" drain. All welds to be full penetration.
Provide level switch with 304 stainless float and rod, with cast iron mounting bushing. Duplex units to have mechanical alternating switches and lead lag capability. Suction isolation valves must not be required to remove one pump for service while the other continues to operate. Simplex units are to have a cut out with removable gasketed cover for future addition of a second pump.

Select options below:

Simplex/Duplex control panel with NEMA 4/12 enclosure, magnetic starter(s), H-O-A selector switches, 110 volt control circuit transformer, main disconnect switch with separate fusing, and run lights for each motor. Panels are to be mounted, wired, and tested before shipment.

Sight glass set with brass valves.

Sight glass set with stainless steel valves.

Stainless steel bi-metal thermometer with 2-1/2" dial and 0 - 250F range.

Replace cast iron/brass float bushing with 304 stainless steel.

Replace cast iron pump discharge with 304 stainless steel.

NOTES